Itrain afam legacyprn8/3/2023 I would suggest that you will have to tell iTrain to switch on the red lamp on a signal if the feedback(s) for the section in advance shows it as occupied, otherwise its yellow lamp if the next in advance is occupied, green if both are vacant. "British 3-aspect signalling" isn't a standard feature of iTrain as such because the package was designed to support all types of signalling, which varies considerably from country to country as well as within countries. The most recent videos are addressing a topic called Apsects, and that may give you a clue but this complex subject has not been covered completely yet. There is a description of all the videos on the iTrain site that Iain referred to above - currently 59 Youtube videos, but more are expected to be produced in due course The first posting on this thread lists not only what each video covers but also where in the clip to find it. When using 128 speed steps, select 126 in iTrain, not sure why they have 126 for 128 steps. I thought this was covered in the iTrain manual ( 5 manual.pdf) but I couldn't find the detail, but it is well worth a read if you haven't. The decoder may need some CVs changing to force it into a certain mode but most are 128 by default or automatically detect what you're using (CV29 covers this normally). You will want DCC assuming you have a typical set up from the UK, the number in the brackets is how many speed steps you need, most decoders available today support 128 speed steps, and you normally set the controller as to how many speed steps you need. There isn't a hard and fast answer to this, as it also depends on your controller and how you set it up more than the actual decoder. I know iTrains can scan CV's to but this drop down confuses me. In crappy old RailMaster it would detect the manufacturer and type for you. so my question is how do I find out which one to use for each type of decoder I have. OK let me rephrase the question - when I add a loco there's a bunch of decoders option in there DCC(16) etc. I think the reason there isn't a video on it is because it's not really within the scope of iTrain, it is just within DCC itself, and that is something that needs to be understood well in advance of trying to automate train movements in iTrain in my humble opinion. When I set up a new decoder I just use my Lokprogrammer, and then tell iTrain where I have mapped the functions to when defining the loco (e.g. There may be some sort of delay in iTrain to account for this (I haven't looked). 0 can mess about with sound decoders hence the high acceleration value too.Īnother point worth noting is that if you have sound decoders set to activate the engine function when starting a route, set the CVs to not wait for the sound finish to start moving, as otherwise you'll get it setting off like mad once the engine has fired up as iTrain has been cranking the speed steps while the loco has been doing its start up sequence. One thing I would do though if wanting to use the inbuilt acceleration/deceleration in iTrain would be to set the relevant CV values to 0 or to at least significantly faster than what you would get out of iTrain, so that the speed step iTrain thinks it is on is the speed step the decoder is actually on. I have a new loco and it's got a decoder in it how do I know which options in iTrain to make it work for some of the common decoders found in the UKįurther to what the decoder/file instructions would tell you what function to map to the function in iTrain.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |